Removing An Autotunnel Backup - Cisco CRS Configuration Manual

Removing an AutoTunnel Backup

Command or Action
Step 5
auto-tunnel backup tunnel-id min minmax max
Example:
RP/0/RP0/CPU0:router(config-mpls-te)#
auto-tunnel backup tunnel-id min 6000 max
6500
Step 6
Use the commit or end command.
Step 7 show mpls traffic-eng auto-tunnel backup
summary
Example:
RP/0/RP0/CPU0:router# show mpls traffic-eng
auto-tunnel backup summary
Related Topics
Backup AutoTunnels, on page 168
Configure the MPLS-TE Auto-Tunnel Backup: Example, on page 356
Removing an AutoTunnel Backup
To remove all the backup autotunnels, perform this task to remove the AutoTunnel Backup feature.
SUMMARY STEPS
1. clear mpls traffic-eng auto-tunnel backup unused { all | tunnel-tenumber}
2. Use the commit or end command.
3. show mpls traffic-eng auto-tunnel summary
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
226
Purpose
Configures the range of tunnel interface numbers to be used for
automatic backup tunnels. Range is 0 to 65535.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Displays information about configured MPLS-TE backup
autotunnels.
Implementing MPLS Traffic Engineering