Configuring Ipcc Control Channel Information; Configuring Router Ids - Cisco CRS Configuration Manual

Configuring GMPLS
•
•
•
•
•
These high-level tasks are broken down into, in some cases, several subtasks.
Note

Configuring IPCC Control Channel Information

To configure IPCC control channel information, complete these subtasks:
•
•
You must configure each subtask on both the headend and tailend router.
Note

Configuring Router IDs

Perform this task to configure the router ID for the headend and tailend routers.
SUMMARY STEPS
1. configure
2. interface type interface-path-id
3. ipv4 address ipv4-address mask
4. exit
5. router ospf process-name
6. mpls traffic-eng router-id type interface-path-id
7. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
242
Configuring Local and Remote TE Links, on page 246
Configuring Numbered and Unnumbered Optical TE Tunnels, on page 258
Configuring LSP Hierarchy, on page 263
Configuring Border Control Model, on page 264
Configuring Path Protection, on page 264
Configuring Router IDs, on page 242
Configuring OSPF over IPCC, on page 244
Purpose
Enters global configuration mode.
Implementing MPLS Traffic Engineering