Explicit Paths; Periodic Backup Promotion; Protocol-Based Cli - Cisco CRS Configuration Manual

Implementing MPLS Traffic Engineering

Explicit Paths

Explicit paths are used to create backup autotunnels as follows:
For NHOP Backup Autotunnels:
• NHOP excludes the protected link's local IP address.
• NHOP excludes the protected link's remote IP address.
• The explicit-path name is _autob_nhop_tunnelxxx, where xxx matches the dynamically created backup
For NNHOP Backup Autotunnels:
• NNHOP excludes the protected link's local IP address.
• NNHOP excludes the protected link's remote IP address (link address on next hop).
• NNHOP excludes the NHOP router ID of the protected primary tunnel next hop.
• The explicit-path name is _autob_nnhop_tunnelxxx, where xxx matches the dynamically created backup

Periodic Backup Promotion

The periodic backup promotion attempts to find and assign a better backup for primary tunnels that are already
protected.
With AutoTunnel Backup, the only scenario where two backups can protect the same primary tunnel is when
both an NHOP and NNHOP AutoTunnel Backups get created. The backup assignment takes place as soon as
the NHOP and NNHOP backup tunnels come up. So, there is no need to wait for the periodic promotion.
Although there is no exception for AutoTunnel Backups, periodic backup promotion has no impact on primary
tunnels protected by AutoTunnel Backup.
One exception is when a manual promotion is triggered by the user using the mpls traffic-eng fast-reroute
timers promotion command, where backup assignment or promotion is triggered on all FRR protected primary
tunnels--even unprotected ones. This may trigger the immediate creation of some AutoTunnel Backup, if the
command is entered within the time window when a required AutoTunnel Backup has not been yet created.
You can configure the periodic promotion timer using the global configuration mpls traffic-eng fast-reroute
timers promotion sec command. The range is 0 to 604800 seconds.
A value of 0 for the periodic promotion timer disables the periodic promotion.
Note

Protocol-Based CLI

Cisco IOS XR software provides a protocol-based command line interface. The CLI provides commands that
can be used with the multiple IGP protocols supported by MPLS-TE.
tunnel ID.
tunnel ID.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Protocol-Based CLI
171