Configuring a Path Computation Client and Element
Command or Action
Related Topics
Path Computation Element, on page 185
Configure PCE: Example, on page 351
Configuring a Path Computation Element Address
Perform this task to configure a PCE address.
Only one TE-enabled IGP instance can be used at a time.
Note
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. pce address ipv4 address
4. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)# mpls
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
282
Purpose
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Enters the MPLS-TE configuration mode.
Implementing MPLS Traffic Engineering