Cisco CRS Configuration Manual page 14

Contents
Implementing GMPLS UNI
C H A P T E R 7
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
xiv
Configure the Ignore IS-IS Overload Bit Setting in MPLS-TE: Example
Configure GMPLS: Example
Configure Flexible Name-based Tunnel Constraints: Example
Configure an Interarea Tunnel: Example
Configure Forwarding Adjacency: Example
Configure Unequal Load Balancing: Example
Configure PCE: Example
Configure Policy-based Tunnel Selection: Example
Configure Tunnels for Path Protection: Example
Configure Tunnels for Explicit Path Protection: Example
Configure Tunnels for Co-existence of Path Protection with Fast Reroute: Example
Configure Automatic Bandwidth: Example
Configure the MPLS-TE Shared Risk Link Groups: Example
Configure the MPLS-TE Auto-Tunnel Backup: Example
Configure Point-to-Multipoint TE: Examples
Configure Point-to-Multipoint for the Source: Example
Configure the Point-to-Multipoint Tunnel: Example
Disable a Destination: Example
Configure the Point-to-Multipoint Solution: Example
Configure MPLS TE Path-selection Cost Limit: Example
Additional References
368
371
Prerequisites for Implementing GMPLS UNI
Restrictions for Implementing GMPLS UNI
Information About Implementing GMPLS UNI
GMPLS UNI vs GMPLS NNI
GMPLS LSP Signaling
372
Path Message without an ERO
XRO Attribute-set 373
Connection Diversity
GMPLS RSVP VRF Signaling
DWDM Transponder Integration
How to Implement GMPLS UNI
Configuring TE for GMPLS UNI
345
349
349
350
351
351
352
353
362
364
371
372
372
372
373
373
373
374
374
374
344
347
352
353
353
356
363
363
364
368