Configuring Ldp Igp Synchronization: Ospf - Cisco CRS Configuration Manual

Configuring LDP IGP Synchronization: OSPF

Command or Action
Step 3
session protection [ for peer-acl ] [ duration
seconds ]
Example:
RP/0/RP0/CPU0:router(config-ldp)# session
protection for peer_acl_1 duration 60
Step 4 Use the commit or end command.
Related Topics
Session Protection, on page 16
Configuring LDP Session Protection: Example, on page 83
Configuring LDP IGP Synchronization: OSPF
Perform this task to configure LDP IGP Synchronization under OSPF.
By default, there is no synchronization between LDP and IGPs.
Note
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
50
Implementing MPLS Label Distribution Protocol
Purpose
Configures LDP session protection for peers specified by peer-acl
with a maximum duration, in seconds.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.