Configuring Local Switching Capability Descriptors - Cisco CRS Configuration Manual

Implementing MPLS Traffic Engineering
Command or Action
bandwidth 2488320 2488320
Step 4 Use the commit or end command.

Configuring Local Switching Capability Descriptors

Perform this task to configure the local switching capability descriptor.
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. interface type interface-path-id
4. flooding-igp ospf instance-id area area-id
5. switching key value [encoding encoding type]
6. switching key value [capability {psc1 | lsc | fsc} ]
7. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2 mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)# mpls
Purpose
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Enters MPLS-TE configuration mode.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Configuring GMPLS
249