Rp/0/Rp0/Cpu0:Router(Config-Ldp) - Cisco CRS Configuration Manual

Configuring LDP Discovery Parameters
Command or Action
Example:
RP/0/RP0/CPU0:router(config-ldp)# discovery
hello holdtime 30
RP/0/RP0/CPU0:router(config-ldp)#
discovery targeted-hello holdtime 180
Step 5 discovery { hello | targeted-hello } interval
seconds
Example:
RP/0/RP0/CPU0:router(config-ldp)# discovery
hello interval 15

RP/0/RP0/CPU0:router(config-ldp)#

discovery targeted-hello interval 20
Step 6 Use the commit or end command.
Step 7
show mpls ldp [vrf vrf-name] parameters
Example:
RP/0/RP0/CPU0:router
# show mpls ldp parameters
RP/0/RP0/CPU0:router
# show mpls ldp vrf red parameters
Related Topics
LDP Control Plane, on page 7
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
26
Implementing MPLS Label Distribution Protocol
Purpose
argument is 15 seconds for link hello and 90 seconds for targeted
hello messages.
Selects the period of time between the transmission of consecutive
hello messages. The default value for the seconds argument is 5
seconds for link hello messages and 10 seconds for targeted hello
messages.
commit-Saves the configuration changes and remains within the
configuration session.
end-Prompts user to take one of these actions:
• Yes- Saves configuration changes and exits the configuration
session.
• No-Exits the configuration session without committing the
configuration changes.
• Cancel-Remains in the configuration session, without
committing the configuration changes.
(Optional)
Displays all the current MPLS LDP parameters.
Displays the LDP parameters for the specified VRF.