Configuring An Ospf Area Of Mpls-Te - Cisco CRS Configuration Manual

Configuring an OSPF Area of MPLS-TE

Command or Action
Step 6
mpls traffic-eng level
Example:
RP/0/RP0/CPU0:router(config-isis-af)# mpls
traffic-eng level-1-2
Step 7 Use the commit or end command.
Configuring an OSPF Area of MPLS-TE
Perform this task to configure an OSPF area for MPLS-TE in both the OSPF backbone area 0 and area 1.
SUMMARY STEPS
1. configure
2. router ospf process-name
3. mpls traffic-eng router-id ip-address
4. area area-id
5. interface type interface-path-id
6. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
274
Purpose
Enters the required MPLS-TE level or levels.
commit—Saves the configuration changes and remains within
the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Implementing MPLS Traffic Engineering