Cisco CRS Configuration Manual page 273

Implementing MPLS Traffic Engineering
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. interface type interface-path-id
4. lmp data-link adjacency
5. remote switching-capability {fsc | lsc | psc1}
6. remote interface-id unnum value
7. remote node-id node-id
8. neighbor name
9. remote node-id address
10. Use the commit or end command.
11. show mpls lmp
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)# mpls traffic-eng
Step 3 interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config-mpls-te)# interface
POS0/6/0/0
Step 4 lmp data-link adjacency
Example:
RP/0/RP0/CPU0:router(config-mpls-te-if)# lmp
data-link adjacency
Step 5
remote switching-capability {fsc | lsc | psc1}
Example:
RP/0/RP0/CPU0:router(config-mpls-te-if-adj)#
Purpose
Enters global configuration mode.
Enters MPLS-TE configuration mode.
Enters MPLS-TE interface configuration mode and enables
TE on a particular interface on the originating node.
Configures LMP neighbor remote TE links.
Configures the remote LMP MPLS-TE interface switching
capability.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Configuring GMPLS
255