Implementing RSVP for MPLS-TE and MPLS O-UNI
Command or Action
Related Topics
Key-source Key-chain, on page 121
Security Association, on page 120
RSVP Neighbor Authentication: Example, on page 151
Configuring a Lifetime for RSVP Neighbor Authentication
Perform this task to configure a lifetime for security association for RSVP neighbor authentication mode.
SUMMARY STEPS
1. configure
2. rsvp neighbor IP-address authentication
3. life-time seconds
4. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
rsvp neighbor IP-address authentication
Example:
RP/0/RP0/CPU0:router(config)# rsvp neighbor
1.1.1.1 authentication
RP/0/RP0/CPU0:router(config-rsvp-nbor-auth)#
Purpose
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Enters RSVP neighbor authentication configuration mode. Use the
rsvp neighbor command to specify a neighbor under RSVP.
IP address
IP address of the neighbor. A single IP address for a specific
neighbor; usually one of the neighbor's physical or logical
(loopback) interfaces.
authentication
Configures the RSVP authentication parameters.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Configuring RSVP Neighbor Authentication
143