Configuring Remote Te Link Adjacency Information For Unnumbered Links - Cisco CRS Configuration Manual
Ios xr mpls configuration guide
Hide thumbs
Also See for CRS:
- User manual (304 pages) ,
- Configuration manual (292 pages) ,
- Command reference manual (155 pages)
Table of Contents
Advertisement
Implementing MPLS Traffic Engineering
Configuring Remote TE Link Adjacency Information for Unnumbered Links
Perform this task to configure remote TE link adjacency information for unnumbered links.
To display the assigned value for the local interface identifiers, use the show mpls lmp command.
Note
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. interface type interface-path-id
4. lmp data link adjacency
5. neighbor name
6. remote te-link-id unnum
7. remote interface-id unnum interface-dentifier
8. remote switching-capability {fsc | lsc | psc1}
9. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)# mpls traffic-eng
Step 3
interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config-mpls-te)#
interface POS0/6/0/0
Step 4
lmp data link adjacency
Example:
RP/0/RP0/CPU0:router(config-mpls-te-if)# lmp
data-link adjacency
Purpose
Enters global configuration mode.
Enters MPLS-TE configuration mode.
Enters MPLS-TE interface configuration mode and enables
TE on a particular interface on the originating node.
Configures LMP neighbor remote TE links.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Configuring GMPLS
257
Advertisement
Table of Contents
