Comtech EF Data SLM-7650 Installation And Operation Manual page 179

SLM-7650 Satellite Modem
Remote Control Specifications
Where 'pn' is the last parameter returned.
Parameter
Number
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Parameter Name
(Command Reference)
Modulator RF output
(ref. 'RF_' command).
Modulator IF frequency
(ref. 'MF_' command).
Modulator rate
(ref. 'MR_' command).
Modulator preset 'A' assignment
(ref. 'ARMA_' command).
Modulator preset 'B' assignment
(ref. 'ARMB_' command).
Modulator preset 'C' assignment
(ref. 'ARMC_' command).
Modulator preset 'D' assignment
(ref. 'ARMD_' command).
Modulator preset 'V' assignment
(ref. 'ARMV_' command).
Modulator power offset
(ref. 'MPO_' command).
Modulator output power level
(ref. 'MOP_' command).
Scrambler enable
(ref. 'SE_' command).
Differential encoder enable
(ref. 'DENC_' command).
Modulator type
(ref. 'MT_' command).
Modulator Encoder Type
(ref. 'MET_' command).
Carrier only mode
Demodulator IF
(ref. 'DF_' command).
Description
p1 = n, where 'n' is '0' (off) or '1' (on).
p2 = nn.nnnnnn, IF frequency in MHz.
p3 = nnnn_mmmmm.mmm, code rate/data rate in kbit/s.
p4 = nnnn_mmmmm.mmm, code rate/data rate in kbit/s.
p5 = nnnn_mmmmm.mmm, code rate/data rate in kbit/s.
p6 = nnnn_mmmmm.mmm, code rate/data rate in kbit/s.
p7 = nnnn_mmmmm.mmm, code rate/data rate in kbit/s.
p8 = nnnn_mmmmm.mmm, code rate/data rate in kbit/s.
p9 = snn.n, transmitter power offset level in dBm.
p10 = snn.n, transmitter output power level in dBm.
p11 = n, where 'n' is '0' (off) or '1' (on).
p12 = n, where 'n' is '0' (off) or '1' (on).
p13 = n, where 'n' is '0' (EFD) or '1' (INTL).
p14 = n, where 'n' is '1' (Viterbi) or '2' (TURBO).
p15 = n, where 'n' is '0' (Normal), '1' (Center),
'2' (Dual), or 3 (Offset).
p16 = nn.nnnnnn, demodulator IF frequency in MHz.
A–37
Revision 4
MN/SLM7650.IOM