Comtech EF Data SLM-7650 Installation And Operation Manual page 168

SLM-7650 Satellite Modem
Remote Control Specifications
A.14 Demodulator Configuration Status
Demodulato Command:
r Config. Response:
Status
<add/DCS_'cr'
>add/DCS_'cr'
DF_nn.nnnnnnn'cr'
DR_nnnn_mmmmm.mmm'cr'
ADRA_nnnn_mmmmm.mmm'cr'
ADRB_nnnn_mmmmm.mmm'cr'
ADRC_nnnn_mmmmm.mmm'cr'
ADRD_nnnn_mmmmm.mmm'cr'
ADRV_nnnn_mmmmm.mmm'cr'
DE_xxx'cr'
DDEC_xxx'cr'
IFL_xxx'cr'
SCF_snnnnn'cr'
SWR_nnnnn'cr'
SR_xxx'cr'
BERT_xxxx'cr'
DT_xxxx'cr'
DDT_xxx'cr'
DSR_xxx'cr'
RSDE_xxx'cr'
RDA_xxx'cr'
DCRT_xxxx'cr'
R310_xxx'cr'
DRSC_nnn_kkk_I'cr''lf']
Demodulator Frequency
Demodulator Rate
Preset 'A' Assignment
Preset 'B' Assignment
Preset 'C' Assignment
Preset 'D' Assignment
Preset 'V' Assignment
Descrambler Enable
Differential Decoder
IF Loopback
Sweep Center Frequency
Sweep Width Range
Sweep Reacquisition
BER Threshold
Demodulator Type
Demodulator Decoder Type
Demodulator Spectrum Rotation
Reed-Solomon Decoder
Receive BPSK Data Ordering
Descrambler Type
RX 8PSK IESS-310 Operation
(Note 1) Reed-Solomon Codeword
The demodulator configuration status command causes a
block of data to be returned by the addressed modem. The
block of data reflects the current configuration of the demod.
Additional configuration status of new options and features
will always be appended to the end.
Notes:
1. Data is only returned when the modem type is set to
CUSTOM and RX Overhead is either NONE or ASYNC.
A–26
Revision 4
MN/SLM7650.IOM