DEVELOPMENT MENU
Debug Port
Print History
SCANNER TESTS
ASIC Test
Feed Test
Scanner Manual Registration
ENGINE ADJUST
ATC SENSOR ADJUST AND
SETUP
Booklet Fold Adj
Finisher Config
EXIT DIAGS
DEVICE TESTS
Flash Test
This test appears only when a non-defective flash memory is installed. Data is written to the flash card and read
back to check the accuracy. This test destroys all data stored on the flash device.
Warning: This test deletes all data stored on the flash device. After the test is over, reformat the flash using
Format Flash in the customer Utilities Menu.
To perform this test:
1.
From the Diagnostics Menu, navigate to DEVICE TESTS > Flash Test.
Contents will be lost. Continue? appears. Touch Yes to continue, or touch No to return to DEVICE
2.
TESTS.
Flash Test Testing... appears while the test is running.
3.
When the test is complete, Flash Test Test Passed or Flash Test Test Failed appears.
4.
Quick Disk Test
This menu item appears only when a non-defective disk is installed. This test performs a non-destructive read/
write on one block per track on the disk. Once executed, the test cannot be canceled.
To perform this test:
From the Diagnostics Menu, navigate to DEVICE TESTS > Quick Disk Test.
1.
Quick Disk Test Testing DO NOT POWER OFF appears.
2.
When the test is complete, Quick Disk Test Test Passed or Quick Disk Test Test Failed appears.
3.
Disk Test/Clean
Warning: This test performs a low-level format of the hard disk which will destroy all data and should never be
performed on a good disk. This test will only be used when the disk contains bad data and is
unusable.
Note: This process does not erase any information stored on the device's NAND.
Do not use. For development use only.
See
"SCANNER TESTS" on page
See
"ASIC Test" on page
3-28.
See
"Feed Test (SCANNER TESTS)" on page
See
"Scanner Manual Registration" on page
7558-xxx
3-28.
3-28.
3-29.
Diagnostic aids
Previous
Next
Go Back
3-19