Disconnect the connector from the booklet diverter gate (A).
5.
Booklet end guide drive motor removal
Remove the booklet unit assembly. See
1.
Remove the booklet unit assembly left cover. See
2.
page
4-337.
Disconnect the connectors from the sensor (booklet end guide drive motor).
3.
Remove the two screws securing the booklet end guide drive motor (A) from the compiler frame.
4.
5.
Remove the booklet end guide drive motor (A).
A
Connector
"Booklet unit chassis removal" on page
"Booklet unit assembly left cover removal" on
7558-xxx
4-338.
Repair information
4-327
Previous
Next
Go Back