Media Entrance Pinch Guide Assembly Removal - Lexmark X95x Series Service Manual

7558-xxx
Make sure the media eject unit assembly properly actuates the switch (eject cover interlock) (H) without
•
binding.

Media entrance pinch guide assembly removal

1. Open the finisher front door assembly.
Remove the rear upper cover. See
2.
Remove the left lower cover. See
3.
Remove the left upper cover. See
4.
Remove the screw securing the cover (A) to the media entrance pinch guide assembly (B).
5.
6. Remove the cover (A).
Disconnect the connector from the sensor (finisher media entrance) (C).
7.
Release the harness from the clamps.
8.
Remove the three screws securing the media entrance pinch guide assembly (B).
9.
Connector
C
10. Remove the entrance pinch guide assembly (B) from the finisher.
Service Manual
4-376
Right
Actuator
"Rear upper cover removal" on page
"Left lower cover removal" on page
"Left upper cover removal" on page
B
Clamp
Left
H
G
4-383.
4-362.
4-363.
A
Rear
Left
B
Previous
Next
Go Back