Lexmark X95x Series Service Manual page 840

7558-xxx
Remove the four screws securing the right panel (C) to the finisher.
6.
C
Remove the media eject motor assembly. See
7.
8. Release the hook of the media eject shaft gear 39T (D) from the eject roll shaft (E).
Remove the media eject shaft gear 39T (D).
9.
Remove the 6 mm bushing (F).
10.
Use a prying tool to remove the e-clip securing the eject roll shaft (E) to the rear of the finisher.
11.
Remove the 8 mm bushing (G).
12.
13. Remove the two e-clips securing the eject roll shaft (E) to the front of the finisher.
Remove the 6 mm bushing (F) and the 8 mm bushing (G).
14.
Move the eject roll shaft toward the rear and outward as shown.
15.
F
D
Service Manual
4-346
B
"Media eject motor assembly removal" on page
E
G
G
E-clips
E-clip
F
Front
Rear
A
Rear
)
4-372.
C
E
Previous
Next
Go Back