Finisher Right Carriage Belt Removal - Lexmark X95x Series Service Manual

7558-xxx
Remove the finisher docking bracket (D).
9.
Reinstallation note: When docking the finisher to the printer, make sure the boss on the finisher docking
bracket (D) is inserted into the hole on the finisher docking latch assembly (C). The finisher should be firmly
locked into position.

Finisher right carriage belt removal

Remove the rear upper cover. See
1.
Remove the finisher front door assembly. See
2.
Move the slip clutch gear 24T (A) toward the rear to disengage the stacker bin (B).
3.
4. Move the stacker bin (B) to its lowest position.
Note: Make sure the stacker bin is at the lowest position before continuing.
Service Manual
4-360
Boss
D
"Rear upper cover removal" on page
"Finisher front door assembly removal" on page
B
C
4-383.
A
Rear
Previous
Next
Go Back
4-351.