Sensor (Stapler Carriage Hp) Removal - Lexmark X95x Series Service Manual

Remove the sensor.
9.
Reinstallation note: Make sure that the yellow connector is plugged into the sensor (stacker bin no media) (C).

Sensor (stapler carriage HP) removal

1. Remove the finisher front door assembly. See
Remove the staple cartridge.
2.
Remove the rear upper cover. See
3.
Remove the rear lower cover. See
4.
Remove the stapler unit frame. See
5.
6. Remove the stapler unit assembly. See
B
C
"Finisher front door assembly removal" on page
"Rear upper cover removal" on page
"Upper media bin front cover removal" on page
"Stapler unit frame removal" on page
"Stapler unit assembly removal" on page
Rear
White connector
Yellow connector
B
C
4-383.
4-415.
Repair information
7558-xxx
Previous
Next
Go Back
4-351.
4-426.
4-413.
4-407