Switch (Finisher Front Door Interlock) Removal - Lexmark X95x Series Service Manual

Remove the two screws securing the switch (eject cover interlock) (A) from the bracket (B).
6.
Connector
A
Remove the switch (eject cover interlock) (A).
7.
Reinstallation note: Make sure the media eject unit assembly (C) properly actuates the switch (media eject
interlock) (A) without binding.

Switch (finisher front door interlock) removal

Open the finisher front door assembly.
1.
2. Remove the rear upper cover. See
Remove the punch waste box (A).
3.
Remove the three screws in the front securing the punch waste chute (B).
4.
Gently pull down the punch waste chute (B) to gain better access to the switch (finisher front door
5.
interlock) (C).
B
Clamp
Right
"Rear upper cover removal" on page
Clamps
A
C
4-383.
7558-xxx
Repair information
4-423
Previous
Next
Go Back