Punch Carriage Assembly Removal - Lexmark X95x Series Service Manual

7558-xxx
Tighten the two screws in the order shown.
•
B

Punch carriage assembly removal

Open the finisher front door assembly.
1.
Remove the rear upper cover. See
2.
Remove the upper media bin assembly. See
3.
Remove the connector from the sensor (punch carriage shift HP) (A).
4.
5. Remove the top cover. See
Release the harness from the punch carriage assembly (B).
6.
Remove the connector from the punch carriage shift motor assembly (C).
7.
Release the two punch unit assembly harnesses from the three clamps on the rear of the finisher.
8.
Disconnect the two punch unit assembly harnesses from the main harness.
9.
10. Remove the screw securing the grounding wire (D) to the punch unit carriage assembly (B).
Service Manual
4-378
Tighten
second
Rear
C
E
"Rear upper cover removal" on page
"Top cover removal" on page
F
D
D
Tighten first
"Upper media bin assembly removal" on page
4-424.
Rear
4-383.
4-425.
Previous
Next
Go Back