3
Check if the motor runs.
Booklet Maker Motor Tests
These tests verify that the booklet maker motors are working properly.
1
Enter the Diagnostics menu, and then navigate to:
Motor Tests > Booklet Maker Motor Tests
2
Select a motor.
3
Check if the motor runs.
DEVICE TESTS
Quick Disk Test
This test performs a non-destructive read/write test on one block per track on the disk. If the block is good, then the
saved data is written back to the disk.
1
Enter the Diagnostics menu, and then navigate to:
DEVICE TESTS > Quick Disk Test
2
Exit the test.
Disk Test/Clean
Warning—Potential Damage: This test destroys all data on the printer hard disk.
This test may run for approximately 1.5 hours depending on the disk size.
1
Enter the Diagnostics menu, and then navigate to:
DEVICE TESTS > Disk Test/Clean
You cannot cancel the test once it has started.
2
Exit the test.
Flash Test
This test examines the condition of the flash drive.
Warning—Potential Damage: This test destroys all data on the flash drive.
1
Enter the Diagnostics menu, and then navigate to:
Device Tests > Flash Test
You cannot cancel the test once it has started.
2
Exit the test.
3
Reformat the flash drive using the Flash Format setting in the Utilities menu.
Service menus
223
7421