Sensor (Punch Unit Motor Encoder) Removal - Lexmark X95x Series Service Manual

Disconnect the connector from the sensor (punch hole select) (C), the sensor (punch cam front) (D), or the
5.
sensor (punch unit HP) (E).
6. Release the hooks securing the sensor(s) to the bracket.
Remove the sensor(s).
7.
Reinstallation note: Make sure the color coded-connectors are connected to the proper sensors, as shown.

Sensor (punch unit motor encoder) removal

Open the finisher front door assembly.
1.
Remove the rear upper cover. See
2.
Remove the upper media bin assembly. See
3.
4. Remove the top cover. See
Remove the punch carriage assembly. See
5.
Disconnect the connector from the punch unit motor assembly (A).
6.
Disconnect the connector from the sensor (punch unit motor encoder) (B).
7.
Remove the harness from the clamp.
8.
Connector
Blue
Black
Connector
White
"Rear upper cover removal" on page
"Upper media bin assembly removal" on page
"Top cover removal" on page
"Punch carriage assembly removal" on page
C
D
A
E
4-383.
4-424.
Repair information
7558-xxx
Previous
Next
Go Back
4-425.
4-378.
4-401