7558-xxx
Release the two clamps (C) to release the harness.
5.
Swing the PCBA door open.
6.
Remove the developer HVPS PCBA. See
7.
Remove the two screws (D) securing the PC/developer drive motor cooling fan to the machine.
8.
9.
Disconnect the cable (E).
Remove the PC/developer drive motor cooling fan.
10.
PC/developer drive motor removal
1.
Remove the rear upper cover. See
Remove the rear lower cover. See
2.
Service Manual
4-140
"Developer HVPS PCBA removal" on page
"Rear upper cover removal" on page
"Rear lower cover removal" on page
4-75.
4-19.
4-17.
Previous
Next
Go Back