Developer Housing (C) Removal - Lexmark X95x Series Service Manual

To install the new carrier (B):
Warning: Ensure that the carrier is installed evenly and uniformly in the assembly, or spillage may occur.
Open the appropriate bag, and dump the appropriate carrier into the appropriate assembly.
1.
Hook
A
2. Rotate the gears in the assembly to evenly distribute the carrier (B).
Warning: Ensure that the two seals are properly positioned in the assembly before replacing the top cover
(A), or spillage may occur which may lead to print quality problems.
Warning: Ensure that the four plastic tabs in the top cover (A), are inserted into the four holes in the
developer unit or the carrier (B) will be ejected from the developer unit assembly which will result in carrier
contamination and print quality problems.
Replace the top cover (A).
3.
Perform the ATC sensor setup and adjustment. Go to
4.

Developer housing (C) removal

Remove the printer front door. See
1.
Remove the transfer belt cleaner. See
2.
Remove the waste toner box.
3.
Remove the four photoconductor units.
4.
5. Remove the four toner supplies.
Remove the operator panel left cover. See
6.
Remove the operator panel right cover. See
7.
Remove the operator panel front cover. See
8.
Remove the printhead retract door. See
9.
10. Remove the inner cover. See
Remove the inner plate. See
11.
Remove the ATC sensor PCB bracket. See
12.
Remove the waste toner auger chute. See
13.
Tabs
B
Seal
"Printer front door removal" on page
"Transfer belt cleaner removal" on page
"Operator panel left cover removal" on page
"Operator panel right cover removal" on page
"Operator panel front cover (MFP) removal" on page
"Printhead retract door removal" on page
"Inner cover removal" on page
"Inner plate removal" on page
"ATC sensor PCB bracket removal" on page
"Waste toner auger chute removal" on page
Hook
Seal
"Sensor (ATC) setup" on page
4-13.
4-4.
4-101.
7558-xxx
4-460.
4-181.
4-10.
4-11.
4-8.
4-148.
4-29.
4-197.
Repair information
4-49
Previous
Next
Go Back