Paddle Shaft Removal - Lexmark X95x Series Service Manual

Paddle shaft removal

Open the finisher front door assembly.
1.
2. Remove the rear upper cover. See
Remove the media eject unit assembly. See
3.
Loosen the screw securing the knob (A) to the paddle shaft (B) on the front of the finisher.
4.
Remove the knob (A).
5.
Remove the one e-clip securing the paddle shaft (B).
6.
7. Remove the bushing (C).
Loosen the two screws securing the belt tensioner bracket (D) to the rear of the finisher.
8.
Release the hook of the sub paddle drive gear 23T (E) from the paddle shaft (B).
9.
Remove the sub paddle drive gear 23T (E).
10.
11. Remove the e-clip and the 6 mm bushing (C).
Move the paddle shaft (B) toward the rear of the finisher and outward.
12.
Remove the paddle shaft (B).
13.
Reinstallation notes:
The tension of the belt (exit) (F) is automatically adjusted by the force of the spring attached to the belt
•
tensioner bracket (D).
"Rear upper cover removal" on page
"Media eject unit assembly removal" on page
B
C
Front
4-383.
4-373.
E-clip
Screw
A
Repair information
7558-xxx
Previous
Next
Go Back
4-377