Device Tests; Disk Test/Clean - Lexmark MX610 Service Manual

The following sensors can be checked using this test:
•
Narrow Media
•
Input
• Exit
•
Front Door
CAUTION—SHOCK HAZARD: Do not use your hand to toggle these switches. Use a nonconducting item.
To run the Base Sensor Test.
1
From the Diagnostics menu, navigate to BASE SENSOR TEST.
2
Choose a sensor.
3
Manually actuate the sensor to verify that it toggles. If the sensor does not toggle, then it is malfunctioning.
4
Press X to exit the test.

DEVICE TESTS

Quick Disk Test
This test performs a non-destructive read/write test on one block per track on the disk. The test reads one block on
each track, saves the data, and then writes and reads four test patterns to the bytes in the block. If the block is good,
then the saved data is written back to the disk.
To run the quick disk test:
1
From the Diagnostics menu, navigate to:
Device Tests > Quick Disk Test.
•
The power indicator blinks while the test is in progress.
•
Quick Disk Test/Test Passed appears if the test passes.
•
Quick Disk Test/Test Failed appears if the test fails.
2
Press X to return to the Device tests menu.

Disk Test/Clean

Warning—Potential Damage: This test destroys all data on the disk and should not be attempted on a good disk.
This test may run approximately 1.5 hours, depending on the disk size.
Sensor Values
Input Open
Output Closed
Front Door
Narrow Media Narrow
Wide
Service menus
190
7016