Sensor (Stacker Bin Upper Limit) Or Sensor (Stacker Bin No Media) Removal - Lexmark X95x Series Service Manual

7558-xxx
Release the hooks securing the sensor to the bracket (B).
5.
6. Remove the sensor (stacker bin level encoder) (A).

Sensor (stacker bin upper limit) or sensor (stacker bin no media) removal

Remove the rear upper cover. See
1.
Remove the rear lower cover. See
2.
3. Remove the stacker media bin assembly. See
page 4-432.
Remove the stacker bin lift motor assembly. See
4.
page 4-410.
Remove the four screws securing the metal cover (A) to the finisher.
5.
6. Remove the metal cover (A).
A
Disconnect the connector from the sensor (stacker bin upper limit) (B) or the sensor (stacker bin no
7.
media) (C).
Release the hooks of the selected sensor.
8.
Service Manual
4-406
"Rear upper cover removal" on page
"Upper media bin front cover removal" on page
"High capacity feeder (HCF) removal procedures" on
"Stacker bin lift motor assembly removal" on
4-383.
4-426.
Right
Previous
Next
Go Back