Upper Media Exit Roll Assembly Removal - Lexmark X95x Series Service Manual

Remove the four screws securing the four upper media exit pinch roll assemblies (A) to the finisher.
5.
Rear
Remove the four upper media exit pinch roll assembly (A).
6.

Upper media exit roll assembly removal

1. Open the finisher front door assembly.
Remove the rear upper cover. See
2.
Remove the upper media bin assembly. See
3.
Remove the top cover. See
4.
Remove the drive motor (exit). See
5.
page 4-420.
Disconnect the connector from the sensor (upper media exit) (A).
6.
Release the harness from the clamps.
7.
Remove the two front and two rear screws securing the upper exit guide assembly (B).
8.
Remove the upper exit guide assembly.
9.
A
"Rear upper cover removal" on page
"Upper media bin assembly removal" on page
"Top cover removal" on page
"Stepper motor (exit) assembly and belt (exit) removal" on
Left
4-383.
4-424.
A
Connector
Left
Repair information
7558-xxx
Previous
Next
Go Back
4-425.
4-427