Finisher Media Entrance Roll Assembly Removal - Lexmark X95x Series Service Manual

Finisher media entrance roll assembly removal

Remove the finisher front door assembly. See
1.
2. Remove the rear upper cover. See
Remove the left upper cover. See
3.
Remove the punch waste box (A) from the finisher.
4.
Remove the screw securing the cover (B) to the media entrance pinch guide assembly.
5.
Remove the cover (B).
6.
7. Lift the media entrance pinch guide assembly (C).
Loosen the two screws securing the belt tensioner bracket (D) to the finisher and move it upward in the
8.
direction of the arrow.
Remove the belt (entrance/paddle) (E) from the entrance drive pulley 20T (F).
9.
C
B
A
Release the hook securing the entrance drive gear 23T (G) to the media entrance roll assembly (H).
10.
11. Remove the entrance drive gear 23T (G).
Remove the entrance drive pulley 20T (F).
12.
Remove the bushing (I).
13.
Remove the e-clip securing the media entrance roll assembly (H) to the front of the finisher.
14.
Remove the bushing (J).
15.
I
F
G
Rear
Move the media entrance roll assembly (H) toward the rear, downward, and then forward.
16.
Remove the media entrance roll assembly (H) through the inside of the finisher.
17.
Note: When removing the media entrance roll assembly (H), do not touch the rubber surface.
"Finisher front door assembly removal" on page
"Rear upper cover removal" on page
"Left upper cover removal" on page
Front
E
D
Second
First
H
J
H
E-clip
4-383.
4-363.
D
Front
Repair information
7558-xxx
Previous
4-351.
Next
Go Back
4-355