Sub Paddle Removal; Switch (Eject Cover Interlock) Removal - Lexmark X95x Series Service Manual

7558-xxx

Sub paddle removal

Remove the upper media bin assembly. See
1.
2. Gently remove the two sub paddles (A) from the two shafts (B).
Reinstallation note: Make sure the sub paddles are properly installed as shown in the figure. The paddles
must not come in contact with the media eject unit assembly (C).

Switch (eject cover interlock) removal

Remove the upper media bin assembly. See
1.
Disconnect the connector from the switch (eject cover interlock) (A).
2.
Release the harness from the two clamps.
3.
Remove the screw securing the bracket (B) to the finisher.
4.
5. Remove the bracket (B) from the square hole in the finisher.
Service Manual
4-422
"Upper media bin assembly removal" on page
A
B
C
"Upper media bin assembly removal" on page
Previous
4-425.
Next
Go Back
4-425.