Remove the throttle grip cable.
Remove the throttle grip.
THROTTLE GRIP REFITTING
Carry out the operations but in the re-
verse order, making sure to match the
hole (1) with the pin (2).
Checking the ignition timing
- Remove the plastic cap on the flywheel cover
- Turn the flywheel until the reference mark «T" on
the rotor matches the reference mark on the fly-
wheel cover as shown in the figure (TDC). Make
sure that the reference 4V on the camshaft control
pulley is aligned with the reference point on the
head, as shown in the second figure. If the refer-
MAIN - 42