Derbi Rambla 250 Manual page 93

Table of Contents

Advertisement

Engine
- Fit the steel shim contacting the bushing and the stationary driving half-pulley.
- Install the appropriate tool as described in the removal phase.
- Tighten the nut and washer to the prescribed torque.
Specific tooling
AP8140535 Front pulley fitting/removal
Locking torques (N*m)
Driving pulley nut 75÷83 (55.4÷61.3 ftlb)
Refitting the transmission cover
- Check there are 2 centring dowels and that the
sealing gasket for the oil sump has been ade-
quately fitted on the transmission cover.
- Replace the cover by tightening the 10 screws to
the prescribed torque.
- Refit the oil filling cap dipstick.
- Refit the steel washer and the driven pulley nut.
- Tighten the nut to the specified torque using the
lock wrench and the torque wrench tools.
- Refit the plastic cover.
Specific tooling
AP8140661 Lock wrench for clutch bell
Locking torques (N*m)
Transmission cover screws 11÷13 (8.1÷9.6 ftlb) Driven pulley shaft nut 54÷60 (39.9÷44.3 ftlb)
End gear
ENG - 93

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents