Download  Print this page

Advertisement

Table of Contents
Maintenance
Check
Park the vehicle on firm and level
ground.
Rest the vehicle on its centre stand.
Unscrew and pull out the measuring
cap-dipstick.
Clean the area in contact with oil with
a clean cloth.
Screw the cap-dipstick fully down into
its tube.
Pull out the cap-dipstick again and
read the level the oil reaches on the
dipstick.
The level is correct when it is close to
the first notch above the little round
mark.
Top-up if necessary.
CAUTION
WAIT SOME MINUTES UNTIL THE ENGINE AND THE EX-
HAUST SYSTEM ARE COLD.
Pour a small quantity of oil through the fill opening and wait about one minute so that the oil
flows evenly into the crankcase.
Check the oil level and top-up, if required.
Top-up with small quantities of oil, until the recommended level is reached.
At the end of the operation, screw and tighten the cap-dipstick.
NOTE
RIDING THE VEHICLE WITH INSUFFICIENT LUBRICATION OR CONTAMINATED OR NOT REC-
OMMENDED LUBRICANTS ACCELERATES THE WEAR AND TEAR OF MOVING PARTS AND
CAN CAUSE IRRETRIEVABLE DAMAGE
Replacement
Park the vehicle on firm and level ground.
Rest the vehicle on its centre stand.
Stop the engine and let it cool down. This will allow the oil to settle into the crankcase and
cool down.
Remove the rear wheel.
CAUTION
WAIT SOME MINUTES UNTIL THE ENGINE AND THE EXHAUST SYSTEM ARE COLD.
MAIN - 36

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: