Download  Print this page


Table of Contents
Refitting the driven pulley
- Refit the clutch bell.
- Make sure that the driving belt is not damaged.
- Check belt for correct width.
Driving belt 250 4T - minimum width
19.5 mm
Driving belt 250 4T - standard width
21.3 ± 0.2 mm
During the wear checks foreseen in the scheduled
maintenance services, check that the rim bottom
of the toothing does not show signs of incisions or
cracking (see figure): the rim bottom of the tooth
must not have incisions or cracking; if it does,
change the belt.
ENG - 90


Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: