Download  Print this page

Advertisement

Table of Contents
Engine
Refitting the flywheel magneto
- Remove the freewheel retention plate indicated
in the photograph
- Remove the transmission gear and the freewheel
- Insert the freewheel on the flywheel as shown in
the photo
- Then refit the flywheel together with the free-
wheel and transmission gear
- Tighten the flywheel fixing nut to the prescribed torque with a multipurpose wrench
- Refit the retention plate
Specific tooling
AP8140252 Multipurpose wrench
Locking torques (N*m)
Flywheel nut 94÷102 (69.4÷75.3 ftlb)
Refitting the starter motor
- Fit and lubricate a new O-ring on the starter mo-
tor.
- Fit the starter motor on the crankcase and lock
the 2 screws to the prescribed torque.
Locking torques (N*m)
Starter motor screws 11÷13 (8.1÷9.6 ftlb)
ENG - 105

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: