Download  Print this page

Advertisement

Table of Contents
Engine
- Remove the roller bearing using the specific
punch.
Specific tooling
020376Y Adapter handle
020456Y Ø 24 mm punch
020363Y Crankshaft oil seal punch D 20 mm
Inspecting the driven fixed half-pulley
Measure the outside diameter of the
pulley bushing.
Check the surface in contact with the
belt to make sure there are no signs of
abnormal wear.
Check the riveted joints work properly.
Check the evenness of the surface in
contact with the belt.
Characteristic
Half-pulley minimum diameter
Minimum diameter allowed: Ø 40.96 mm
Half-pulley standard diameter
Standard diameter: Ø 40.985 mm
wear limit
0.3 mm
ENG - 86

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: