Terminal Function Selection - Toshiba TOSVERT VF-MB1 Instruction Manual

6.3

Terminal function selection

6.3.1 Keeping an input terminal function always active (ON)
f104 : Always active function selection 1
f108 : Always active function selection 2
f110 : Always active function selection 3
 Function
This parameter specifies an input terminal function that is always to be kept active (ON).
[Parameter setting]
Title
f104 Always active function selection 1
f108 Always active function selection 2
Always active function selection 3
f110
Explanation of the coast stop function
When ST (Standby) is OFF, coast stops.
The default setting for ST (Standby) is ON, change the
following settings.
  (no function)
 Assign open input terminal 6: ST (Standby).
Coast stops if terminal set for ST (Standby) is set to
OFF. The monitor on the inverter at this time displays

Note1) Input terminal function 8, 9 (Reset command and its inversion) cannot be assigned.
Function
0-153 (Refer to section 11.6.)
0-153 (Refer to section 11.6.)
0-153 (Refer to section 11.6.)
F-7
Adjustment range Default setting
0 (No function)
0 (No function)
Coast stop
Motor
speed
F-CC
ST-CC
E6581697
6 (ST)
6
ON
OFF
ON
OFF