Toshiba TOSVERT VF-MB1 Instruction Manual page 122

An example of the connection of
the open collector OUT (sink logic)
 Output terminal setting
6
6.1.2
f102 : Speed reach detection band
 Function
[Parameter setting]
Parameter setting of designated frequency and detection band
f102
Parameter setting of output terminal selection
f131
Setting value 7 is reverse signal.
Note: Set f132 to output to FLA-FLC-FLB terminals and f130 to RY-RC terminal.
+24V
P24
OUT
Ry
NO
CC
Default outputs low-speed signal (ON signal) to RY-RC terminal. This setting must be changed to invert
the polarity of the signal.
[Parameter setting]
Title
f130 Output terminal selection 1A (RY-RC)
Setting value 5 is reverse signal.
Note) Set f132 to output to FLA-FLC-FLB terminals and f131 to OUT terminal.
Output of designated frequency reach signal
When the output frequency becomes equal to the setting by designated frequency  f102, an ON
or OFF signal is generated.
Title Function
Speed reach detection band
Title Function
Output terminal
selection 2A (OUT)
An example of the connection of
the relay output terminals
Function Adjustment range
(Refer to section 11.7)
0.0-fh (Hz)
Adjustment range
0-255 6: RCH (Output frequency attainment signal
(Refer to section 11.7.)
F-2
+24V
RY
RC
Default setting
4: LOW (Low-
0-255
speed detection
signal)
Adjustment range Default setting
Default setting
(acceleration/deceleration completed))
E6581697
2.5