(Continued)
Item displayed
Input voltage
Note 3
Output voltage
Input terminal
Note 4
Output terminal
Note 5
Cumulative
Note 9
operation time
Past trip 1
* The monitor value of a trip is not always recorded as the maximum value because of the time required for
detection.
Refer to page H-8 for notes.
Panel
LED display
operated
The inverter input voltage (DC detection) when the trip
occurred is displayed. (%/V).
The inverter output voltage when the trip occurred is
displayed. (%/V)
The ON/OFF status of each of the control signal input
terminals (F, R, RES, S1, S2, S3, VIB, VIA) are displayed in
bits.
ON:
OFF:
}}i}}i}i
The ON/OFF status of each of the control signal output
terminals (RY-RC, OUT, FL) are displayed in bits.
ON:
OFF:
0 }ii
The cumulative operation time when the trip occurred is
displayed.
(0.1=10 hours, 1.00=100 hours)
Press this key to return to past trip 1.
MODE
H-5
Description
}}i}}i}i
F
VIA
R
VIB
S3
RES
S2
S1
0
}ii
FL
OUT
E6581697
RY-RC
8