Selection Of Operation Panel Stop Pattern - Toshiba TOSVERT VF-MB1 Instruction Manual

6.29.9 Selection of operation panel stop pattern

f721 : Selection of operation panel stop pattern
 Function
This parameter are used to select a mode in which the motor started by pressing the
the operation panel is stopped when the
1) Deceleration stop
The motor slows down to a stop in the deceleration time set with  (or  or  ).
2) Coast stop
The inverter cuts off power supply to the motor. The motor comes to a stop after coasting for a while by
inertia. Depending on the load, the motor may keep running for a good long time.
[Parameter setting]
Title
Selection of operation panel stop
f721
pattern
key is pressed.
STOP
Function
0: Deceleration stop
1: Coast stop
F-113
Adjustment range
E6581697
RUN key on
Default setting
6
0