The inverter was factory-configured by default so that if both forward and reverse run signals from
terminal board are ON simultaneously, the motor will decelerate to stop.
However, you can use the parameter to select deceleration stop or reverse run.
5.9
Maximum frequency
: Maximum frequency
Function
1) Programs the range of frequencies output by the inverter (maximum output values).
2) This frequency is used as the reference for acceleration/deceleration time.
Output frequency
80Hz
60Hz
If is increased, adjust the upper limit frequency as necessary.
[Parameter setting]
Title
Maximum frequency
(Hz)
0
100%
Function
E-15
When =80Hz
・This function determines the value
in line with the ratings of the motor
and load.
・Maximum frequency cannot be
When =60Hz
adjusted during operation.To
adjust, first stop the inverter.
Frequency setting signal (%)
Adjustment range
30.0-500.0 (Hz)
E6581697
5
Default setting
80.0