Toshiba TOSVERT VF-MB1 Instruction Manual page 257

(3) The logical product (AND) or logical sum (OR) of the two
functions assigned is put out as a signal.
Setting of output terminal function
Terminal
Title
symbol
RY-RC

OUT 
RY-RC

OUT

RY-RC/

OUT
Two different functions can be assigned to the output terminals (RY-RC and OUT-NO), and two logics with
different functions can be selected using .
The logical product (AND) or logical sum (OR) of the two functions assigned is put out as a signal, depending
on the setting of parameter .
If  = , the logical sum (AND) of  and  will be output to RY-RC.
The logical product (OR) of  and  will be output to OUT-NO.
If  = , the logical product (OR) of  and  will be output to RY-RC.
The logical sum (AND) of  and  will be output to OUT-NO.
If  = , the logical sum (AND) of  and  will be output to RY-RC.
The logical product (OR) of  and  will be output to OUT-NO.
If  = , the logical product (OR) of  and  will be output to RY-RC.
The logical product (OR) of  and  will be output to OUT-NO.
To assign only one function to output terminals, assign the function to  and while leaving
f137 to f139 as they are set by default.
Note: f138 (OUT-NO): Enable only when f669=0
Function
Output terminal selection 1A
Output terminal selection 2A
Output terminal selection 1B
Output terminal selection 2B
Output terminal logic selection
Disabled and the set value cannot be read out, if f669 is set to 1.
G-9
Adjustment range
0-255
0:  and 
 and 
1:  or 
 and 
2:  and 
 or 
3:  or 
 or 
E6581697
Default setting
4
(LOW)
6
(RCH)
255
(always ON)
255
(always ON)
0
7