Installing Windows 2000 Server - Fujitsu Primergy RX600 S2 User Manual

Chapter 4 Manual OS Installation
9
Install the SAF-TE driver.
1. Insert the ServerStart CD-ROM into the drive of the server.
When the ServerStart window appears, exit ServerStart.
2. Click [Start] → [Administrative Tools] → [Computer Management].
3. Click [Device Manager].
4. Double-click [TOSHIBA SAF-TE SCSI Processor Device] under [System devices].
The properties window appears.
5. Click the [Driver] tab and click [Update Driver].
The "Hardware Update Wizard" window appears.
6. Select [Install from a list or Specific location (Advance)] and click [Next].
7. Select [Don't search. I will choose the driver to install] and click [Next].
8. Select [FSC SCSI Termination Module] and click [Next].
Installation starts. When it is completed, a completion message appears.
9. Click [Finish].
10. Click [Close] to close the properties window.
10
Installing high reliability tools.
To ensure stable server operation, refer to "Chapter 6 High Reliability Tools" ( pg.171) and
install high reliability tools.
The installation of Windows Server 2003 has completed.
●
Before Starting Operation
After OS installation, refer to "Chapter 5 Operations after OS Installation" ( pg.133) and perform the
necessary procedures.

4.2.3 Installing Windows 2000 Server

1
Create driver disks.
Prepare necessary drivers before installing Windows 2000 Server.
Some drivers used with Windows 2000 Server are created from the ServerStart CD-ROM. For
how to create driver disks, refer to "4.1 Creating Driver Disks" ( pg.112).
2
Insert the Windows 2000 Server CD-ROM.
Turn on the server and insert the Windows 2000 Server CD-ROM immediately into the CD-ROM
drive. Check there are no floppy disks in the floppy disk drive. When the active area is specified
on the hard disk, the following message appears.
Press any key to boot from CD....
Pressing any key while this message is displayed boots the system from the CD-ROM.
122