Chapter 4 Manual OS Installation
4.3 Installing the LAN Driver
This section explains the procedure for installing the driver.
In addition to the case where the OS is installed manually, the driver must be installed
when a LAN card is added.
4.3.1 Installing the LAN Driver (Windows Server 2003 x64)
Perform the following procedures on all LAN device names under [Network adapters] in [Device
Manager].
1
Double-click a LAN device name under [Network adapters].
2
Insert the driver disk created from the ServerStart CD-ROM into the server.
3
Click [Update Driver] in the [Driver] tab window.
The "Welcome to the Hardware Update Wizard" window appears.
4
Check [No, not this time] and click [Next].
5
Select [Install the software automatically (Recommended)] and click [Next].
The driver will be installed.
6
Click [Finish].
7
Click [Close] to close the properties window.
If PG-1862 LAN driver is installed, LAN adapter name is changed to "Intel(R) PRO/1000 MT Dual Port
Server Adapter" after installation.
126
Names of the LAN devices are displayed as follows.
LAN cards
Onboard LAN (1000BASE-T)
PG-286
PG-1862
PG-1882
PG-1892
table: LAN device name
LAN device name
Broadcom NetXtreme Gigabit Ethernet
Intel(R) PRO/1000 P Dual Port Server Adapter
Intel(R) PRO/1000 MT Dual Port Server Adapter
Intel(R) PRO/1000 MF Server Adapter
Intel(R) PRO/1000 MT Server Adapter