Fujitsu Primergy RX600 S2 User Manual page 208

Chapter 7 Installing Internal Options
ISDN cards
The ISDN card (PG-1651) has a terminal resistor. The rosette or card farthest from the DSU must be
enabled.
Installing the Remote Service Board
Notes Before Installing
When installing the remote service board, note the following points:
Connecting the Server Control Cable
When installing the remote service board, the server control cable needs to be connected.
Connect the server control cable that came with the remote service board as shown in the figure below.
Connect one end to the connector on the remote service board and the other end to the connector on the
baseboard. Then install the remote service board in PCI Slot 7.
208
• Do not connect the remote service board AC adapter until you finish installing
the remote service board and attaching all the server covers. Doing so may
cause a device failure, fire, or electric shock.
• When replacing remote service boards or adding other optional devices,
unplug the power cable of the remote service board AC adapter from the outlet
before operation. Failure to do so may cause a device failure, fire, or electric
shock.