Fujitsu Primergy RX600 S2 User Manual page 25

b Video connector (
Connects display cable.
c USB connector (
Connects peripheral equipment conforming to the USB standard.
d LAN (10/100/1000BASE-T) connector (
Connects an Unshielded Twisted Pair (UTP) cable.
For 1000Mbps connection, a category 5 enhanced cable is required.
For 10Mbps/100Mbps connection, a category 5 or higher cable is required.
The meaning of the LED is shown in the table below.
LED location
LED A
LED B
e PCI Slots
Contains extension cards that enhance the server functions.
f Inlet
Connects power cables.
g Power supply unit status LED
Indicates Power supply unit activity status.
table: Meaning of the Power Supply Unit Status LED
LED
Right, Green, On
Center, Amber, Blinking
Left, Green, On
Off
h System ID LED button
When pressing this button, the front and rear LEDs are lit blue so that the locations of devices
being maintained can be determined.
i System ID LED
When pressing the System ID LED button, this LED is lit blue so that the locations of devices
being maintained can be determined.
Also, the [System Identification LED Display] button of ServerView can be used to light them.
)
)
table: Meaning of the LAN Connector LED
LED
Amber, On Connection established at 1000Mbps
Green, On Connection established at 100Mbps
Off Connection established at 10Mbps
Green, On Link is being established
Green, Blinking Data is being transferred
State
Idle
Failure
Normal operation
No power is supplied
PRIMERGY RX600 S2 User's Guide
)
Description
1
25