Fujitsu Primergy RX600 S2 User Manual page 187

12
Install the VRM.
The installing location differs depending on where the CPU was added. Install the VRM in the
VRM slot at the wall side of the server when you added CPU3, install the VRM in the VRM slot
at center side of the server when you added CPU4.
Align a notch of the VRM with the slot and insert the VRM vertically in the slot.
When the module is correctly inserted, the retention clips on both sides will close. Then, check
that the VRM is securely fastened.
If the retention clips are not securely closed, press them closed with your fingers.
VRM Slot (for CPU4, center side of the server)
VRM Slot (for CPU3, wall side of the server)
13
Install the center brace.
Install the cable through the cable route. At this time, make sure that the cable is not pinched.
After you install it, press the locks on the sides of the server in the direction of the arrow to fasten
it.
Locks
14
Install the memory board and its cover.
PRIMERGY RX600 S2 User's Guide
VRM
Cable route
1
2
3
4
5
6
7
8
9
187