Fujitsu Primergy RX600 S2 User Manual page 149

■ Starting ServerStart
●
When Creating a DOS Floppy Disk on a Client Computer
For Windows 2000 Professional/Windows XP Professional, and if the contents
of the ServerStart CD-ROM has been copied to the computer
1
Click [Start] → [Programs] → [Fujitsu ServerStart] → [ServerStart].
ServerStart starts up and the [Welcome to ServerStart] window appears.
For Windows NT, or if the ServerStart CD-ROM has not been copied to the
computer
1
Insert the ServerStart CD-ROM into the client computer's CD-ROM drive.
ServerStart starts up and the [Welcome to ServerStart] window appears.
●
When Creating a DOS Floppy Disk on the Server
1
Turn on the server and insert the ServerStart CD-ROM immediately after that.
ServerStart starts up and a message appears prompting you to insert the ServerStart floppy disk.
2
Insert the attached "ServerStart floppy disk" into the server's floppy disk drive.
Then make sure "Removable media" and "A:" are selected and click [Create].
A network setup window for remote installation appears.
If a configuration file already exists in the ServerStart floppy disk and [OK] is clicked without
clicking [Create], the [ServerStart Unattended Mode] window appears. Make sure to click
[Exit]. The [Welcome to ServerStart] window appears.
If [Start] is clicked in the [ServerStart Unattended Mode] window, the installation of the server
will start and all disk contents will be deleted.
PRIMERGY RX600 S2 User's Guide
5
149